Skip to the beginning of the images gallery

Porch & Floor Enamel Interior / Exterior Acrylic

Interior/Exterior Porch & Floor Acrylic Coating is a premium interior/exterior 100% acrylic latex floor finish for use on steps, concrete and wood floors. Ideal for painting basement and utility room floors, concrete patios and porches. The low odour, fast dry formula is suited for household or light industrial uses. A pearl sheen provides moderate non-skid surface characteristics. Where additional slip resistance is required, a particle aggregate may be added to the coating. Check with vendor representative for recommendations. Provides good resistance to alkalis and ultra-violet light. Approved by the Master Painter's Institute under category # 60.

PRICE $78.89

description

Name:Porch & Floor Enamel Interior / Exterior Acrylic
Category:Interior Paint
Classification:For Porches & Floors
Chemistry:100% Acrylic Latex
Sheen:GL3 "Pearl" or "Satin"
Size/Liters:01 05 14
Product ID:47
Product Code:02503

Product Features:
NULL
Product Description Marketing:
Interior/Exterior Porch & Floor Acrylic Coating is a premium interior/exterior 100% acrylic latex floor finish for use on steps, concrete and wood floors. Ideal for painting basement and utility room floors, concrete patios and porches. The low odour, fast dry formula is suited for household or light industrial uses. A pearl sheen provides moderate non-skid surface characteristics. Where additional slip resistance is required, a particle aggregate may be added to the coating. Check with vendor representative for recommendations. Provides good resistance to alkalis and ultra-violet light. Approved by the Master Painter's Institute under category # 60.

application

Best paint for:

• Concrete floors
• Wood floors
• Steps
Surface preparation:
Surface preparation is important. All surfaces must be smooth, clean, dry, free of mildew, grease, soap film, sanding dust or other contaminants. Remove all loose or peeling material from previously-painted surfaces. Wash all surfaces with a solution of 3 tablespoons of (Phosphate-free) TSP in a gallon of warm water. Rinse thoroughly, allow to dry and then scuff sand using 80-120 grit sandpaper on a hand sander. Remove all sanding dust. Do not apply at temperatures below 10˚C (50˚F).

WARNING! If you scrape, sand or remove old lead paint from any surface you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to control lead exposure. Carefully clean up with a wet mop or HEPAvacuum. For additional information, Canadian customers contact the Product Safety division of Health Canada at 1-800-O-CANADA, US customers contact the U.S. EPA/Lead Information Hotline at 1-800-424-LEAD (5323).
Recommended Primers:
Pre-Painted Surfaces: Self-Priming on properly-prepared pre-painted surfaces. Wash with a solution of 3 tablespoons of (Phosphate-free) TSP in a gallon of warm water. Rinse thoroughly, allow to dry, and then scuff sand using 80 to 120 grit sandpaper on a hand sander. Remove all sanding dust.

New or Bare Wood: Use Cloverdale Exterior Alkyd (15130) or Acrylic (05130).

Masonry: Self-priming or Cloverdale Latex Block Filler (05700).
Recommended Substrate:
Pre-Painted Surfaces Concrete / Masonry Brick Ferrous Metals Particle Board New Wood Weathered Wood Interior Concrete Floors Wood Floors