VISIT MAIN SITE
My Account
Toggle Nav
Prime Solution Acrylic Bonding Primer
An Interior/Exterior Waterborne Acrylic Bonding Primer with excellent adhesion and lower odour than other quick drying primers for hard, non porous surfaces. This product features high hiding properties and is ideal where drastic colour change is required. Approved under the Master Painter's Institute under category #17.
$77.89
- Prime Solution Acrylic Bonding Primer
- Exterior Paint
- Interior Primers & Sealers
- Acrylic Latex
- Primer - Sealer
- 01 05 14
- 63
- 05910
-
Product Features:
• Excellent adhesion, high hiding properties
• Easy application, good build properties
• Low odour, low VOC's
• 100% acrylic resins
• Quick dry, early topcoat
• Good topcoat compatibility
• Excellent "bonding" primer -
Product Description Marketing:
An Interior/Exterior Waterborne Acrylic Bonding Primer with excellent adhesion and lower odour than other quick drying primers for hard, non porous surfaces. This product features high hiding properties and is ideal where drastic colour change is required. Approved under the Master Painter's Institute under category #17.
-
Best paint for:
• Metal & millwork
• Fiberglass, plastic, tile
• Glass, ceramics -
Surface preparation:
Surface preparation is important. All surfaces must be smooth, clean, dry, free of mildew, grease, soap film, sanding dust or other contaminants. Remove all loose or peeling material from previously-painted surfaces. Wash all surfaces with a solution of 3 tablespoons of (Phosphate-free) TSP in a gallon of warm water. Rinse thoroughly, allow to dry and then scuff sand using 80-120 grit sandpaper on a hand sander. Remove all sanding dust. Do not apply at temperatures below 10˚C (50˚F).
WARNING! If you scrape, sand or remove old lead paint from any surface you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to control lead exposure. Carefully clean up with a wet mop or HEPAvacuum. For additional information, Canadian customers contact the Product Safety division of Health Canada at 1-800-O-CANADA, US customers contact the U.S. EPA/Lead Information Hotline at 1-800-424-LEAD (5323).
-
Recommended Primers:
NULL -
Recommended Substrate:
Prepainted Drywall / Gypsum Pre-Painted Surfaces Concrete / Masonry Stucco Brick Ferrous Metals Particle Board New Wood Weathered Wood Composite Siding Composite Wood Vinyl Glass Plastic Interior Concrete Floors Acoutstical Tile Fibreglass
