VISIT MAIN SITE
My Account
Toggle Nav
- Seal 'n' Shine Concrete Glaze & Sealer - Gloss Base
- Exterior Topcoat
- Alkyd
- GL6 "Gloss"
- 05 10
- 45110
-
Product Features:
- Very fast drying – can bear light foot traffic in 4 hours
- Crystal clear, non-yellowing, and UV resistant
- Easy touch-up in heavy traffic areas
- Protects concrete and masonry from moisture degradation
- Highlights the colour of exposed aggregate concrete and stone
- Breathable – allows moisture in the substrate to escape
- Paintable clear sealer
-
Product Description Marketing:
Seal 'n Shine concrete glaze is a solvent based acrylic penetrating sealer for concrete, brick, exposed aggregate, tile, mortar and masonry block. This product will protect concrete and masonry surfaces from spalling, efflorescence, de-icing salts, oils, grease and freeze-thaw damage. The film is very clear, non-yellowing, abrasion resistant, non-lifting and is suitable for interior or exterior exposure. This product is VOC compliant under Environment Canada regulations and is approved by the Master Painters Institute under category #34 & 104.
-
Best paint for:
- Exposed aggregate driveways
- Pathways, steps
- Concrete, concrete blocks
-
Surface preparation:
Surface preparation is important. All surfaces must be smooth, clean, dry, free of mildew, grease, soap film, sanding dust or other contaminants. Remove all loose or peeling material from previously-painted surfaces. Wash all surfaces with a solution of 3 tablespoons of (Phosphate-free) TSP in a gallon of warm water. Rinse thoroughly, allow to dry and then scuff sand using 80-120 grit sandpaper on a hand sander. Remove all sanding dust. Do not apply at temperatures below 10˚C (50˚F).
WARNING! If you scrape, sand or remove old lead paint from any surface you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to control lead exposure. Carefully clean up with a wet mop or HEPAvacuum. For additional information, Canadian customers contact the Product Safety division of Health Canada at 1-800-O-CANADA, US customers contact the U.S. EPA/Lead Information Hotline at 1-800-424-LEAD (5323).
-
Recommended Primers:
N/A -
Recommended Substrate:
Pre-Painted Surfaces Concrete / Masonry Glazed Tile / Brick Interior Concrete Floors
