Timberlox Waterborne Alkyd Varnish, GL5 Semi-Gloss - Clear

Timberlox Waterborne Alkyd Varnish, GL5 Semi-Gloss - Clear

Timberlox Interior Waterborne Urethane Varnish, Satin (GL2) - Clear Satin

Timberlox Interior Waterborne Urethane Varnish, Satin (GL2) - Clear Satin

Sunfast® Exterior Waterborne Wood Finish Cedar Tone, Satin (GL2)

SUNFAST EXT. WB WD. FIN. SAT CDRTNE
$107.12
  • Sunfast® Exterior Waterborne Wood Finish Cedar Tone, Satin (GL2)
  • Varnish & Clear Coat
  • Acrylic Latex
  • GL2 "Eggshell" or "Satin"
  • 05 10
  • 56615
  • Product Features:

    • Excellent adhesion, durability and wear resistance
    • Low odour formulation
    • Resists cracking, peeling, and damage caused by the sun's UV rays
    • Contains trans-oxide pigments that provide superior UV protection on wood surfaces
    • Can be tinted to darker semi-transparent colours
    • Contains an organic fungicide that resists mildew
    • Contains micro-crystalline waxes that add excellent water repellence properties
    • Soap and water clean-up
  • Product Description Marketing:

    A cedar-toned finish for use on new or previously stained interior or exterior wood. This product possesses excellent weather and sunlight resistance combined with toughness and durability to provide a high degree of protection for exterior woods. Toned with Trans-oxide pigments provides for maximum weathering resistance. This water-based product is low odour and non-flammable and meets all relevant standards for solvent or VOC emissions. It is an environmentally friendly product with soap and water cleanup and has much faster dry times than solvent based products.

  • Best paint for:

    Wood decks, Furniture, Shelving, Cabinets, Doors, Woodwork

  • Surface preparation:

    Surface preparation is important. All surfaces must be smooth, clean, dry, free of mildew, grease, soap film, sanding dust or other contaminants. Remove all loose or peeling material from previously-painted surfaces. Wash all surfaces with a solution of 3 tablespoons of (Phosphate-free) TSP in a gallon of warm water. Rinse thoroughly, allow to dry and then scuff sand using 80-120 grit sandpaper on a hand sander. Remove all sanding dust. Do not apply at temperatures below 10˚C (50˚F).

  • Recommended Primers:

    New or Bare Wood: Self-Priming

  • Recommended Substrate:

    Pre-Painted Surfaces Particle Board New Wood Weathered Wood